The original paper is in English. Non-English content has been machine-translated and may contain typographical errors or mistranslations. ex. Some numerals are expressed as "XNUMX".
Copyrights notice
The original paper is in English. Non-English content has been machine-translated and may contain typographical errors or mistranslations. Copyrights notice
Um guia de ondas metálico que possui um conjunto de hastes dielétricas localizadas a uma distância da parede lateral de aproximadamente um quarto da largura do guia de ondas foi proposto anteriormente para propagação monomodo em uma ampla faixa de frequência. Neste estudo, o S parâmetros de tal guia de ondas foram medidos para o TE10 modo.
The copyright of the original papers published on this site belongs to IEICE. Unauthorized use of the original or translated papers is prohibited. See IEICE Provisions on Copyright for details.
Copiar
Yoshihiro KOKUBO, Tadashi KAWAI, "Fabrication of Wide Band Metallic Bend Waveguide with Asymmetric In-Line Dielectric Rods" in IEICE TRANSACTIONS on Electronics,
vol. E92-C, no. 12, pp. 1538-1540, December 2009, doi: 10.1587/transele.E92.C.1538.
Abstract: A metallic waveguide that has an array of dielectric rods located at a distance from the side wall of approximately one quarter the waveguide width was previously proposed for single mode propagation over a wide frequency range. In this study, the S parameters of such a waveguide were measured for the TE10 mode.
URL: https://global.ieice.org/en_transactions/electronics/10.1587/transele.E92.C.1538/_p
Copiar
@ARTICLE{e92-c_12_1538,
author={Yoshihiro KOKUBO, Tadashi KAWAI, },
journal={IEICE TRANSACTIONS on Electronics},
title={Fabrication of Wide Band Metallic Bend Waveguide with Asymmetric In-Line Dielectric Rods},
year={2009},
volume={E92-C},
number={12},
pages={1538-1540},
abstract={A metallic waveguide that has an array of dielectric rods located at a distance from the side wall of approximately one quarter the waveguide width was previously proposed for single mode propagation over a wide frequency range. In this study, the S parameters of such a waveguide were measured for the TE10 mode.},
keywords={},
doi={10.1587/transele.E92.C.1538},
ISSN={1745-1353},
month={December},}
Copiar
TY - JOUR
TI - Fabrication of Wide Band Metallic Bend Waveguide with Asymmetric In-Line Dielectric Rods
T2 - IEICE TRANSACTIONS on Electronics
SP - 1538
EP - 1540
AU - Yoshihiro KOKUBO
AU - Tadashi KAWAI
PY - 2009
DO - 10.1587/transele.E92.C.1538
JO - IEICE TRANSACTIONS on Electronics
SN - 1745-1353
VL - E92-C
IS - 12
JA - IEICE TRANSACTIONS on Electronics
Y1 - December 2009
AB - A metallic waveguide that has an array of dielectric rods located at a distance from the side wall of approximately one quarter the waveguide width was previously proposed for single mode propagation over a wide frequency range. In this study, the S parameters of such a waveguide were measured for the TE10 mode.
ER -